High Quality Bearings

■In order to avoid the double cooperation of NKX and NKXR bearings, the thrust bearing components should be free in the bearing seat (outer diameter at least D, or D2+0. NX, NX. Of 1% preload.5.Design and safety guidelines for combined needle roller bearings:

■See Table 1 for shaft and bearing seat design.5).Z series

■For combined needle roller bearings without an inner ring, the shaft must be designed to be used as a rolling bearing raceway, or IR or LR series inner ring. Axial application example of bearing without load ■For example, additional spring applies preload to compensate for thermal expansion.Z, NKXR, NKXR.25mm.Z series

■ In order to withstand the axial force, the bearing application:-the stop ring installed in the outer ring groove such as WR or SW-bearing seat shoulder support. NX, NX. NKIB series

■The axial load cannot exceed 25% of the radial load..z, NKX, NKX.

■The axial static load safety factor So should be greater than 1.

■Bearings with plastic cages shall not exceed the allowable operating temperature +120CNKIA series during continuous operation

■The axial load shall not exceed 25% of the radial load.

■The bearing allows axial movement of 0.

■Narrow inner ring parts have larger apertures..5..

■The two inner ring parts must be axially clamped together.

■Thrust bearing components must be applied to the axial basic static load rating C.

■The axial static load safety factor So should be greater than 1.

■Two sets of bearings must be installed opposite to each other to support axial loads that change in directions.08 ~ 0.

■If you want to keep the axis distance to the minimum size, you should increase the gap of the stop ring.

■Bearings must be installed opposite each other to support axial loads that change in directions. If K6 shaft tolerance is adopted, the result is Wholesale non-standard bearings suppliers press fit.